top of page

Installation guide

Learn to install Abrebox A10Pro step by step

ABREBOX.JPG

Shortcuts:

caja a10pro-1.jpg

1. How to anchor the pieces

pc software abrebox.jpg

4. How to activate the service

conexiones a10pro-1.jpg

2. How to connect the wires

Captura de pantalla 2020-11-20 a las 10.11.30.png

5. How the app works

depositphotos_184351500-stock-photo-modem-router-switch-with-rj45.jpeg

3. How to connect it to the Internet

abreboxmurcia.jpg

6. How to check its operation

1. How to anchor each piece.

1.1. Power supply anchor:
Installation of Abrebox 12VDC power supply on DIN rail.

Captura de pantalla 2022-05-31 a las 15.31.21.png

1st. We anchor the power supply to the DIN rail.

Captura de pantalla 2022-05-31 a las 15.31.44.png

2nd. We mount and unmount the source using the tab.

1 Anclar piezas

1.2. Street panel anchor:

Captura de pantalla 2022-05-31 a las 15.32.09.png

1st. We house the box (155x382x32mm) on the wall in  surface/recessed mode at a max. 160cm.

Captura de pantalla 2022-05-31 a las 15.32.38.png

2nd. We attach the panel (173x393x34mm) to the box with the two upper metal anchors.

Captura de pantalla 2022-05-31 a las 15.32.48.png

3rd. We attach the panel to the box with the two lower metal anchors and screw.

2. How to connect the cables.

Power supply connection, door opener, Internet and wiring requirements.

esquema de conexiones Abrebox Intercom A10Pro.png
Captura de pantalla 2022-05-31 a las 15.40.18.png
Ancla 2 cables

3. How to connect to the Internet.

Connect your street panel to the Internet via SIM card, RJ45 to router or by WIFI.

Captura de pantalla 2022-05-31 a las 15.43.03.png

Option 1:

SIM CARD 4G

 

Insert the MicroSIM card into the slot you will find on the back of the device. Before inserting it, make sure to disable the PIN code of it. After the device is turned on, the street panel will configure its APN automatically.

Captura de pantalla 2022-05-31 a las 15.43.17.png

Option 2:

RJ45

 

You can connect the street panel through CAT5/CAT6 cable to the router. To do this, there is an RJ45 type input on the connection strip. Just plug and play!

Captura de pantalla 2022-05-31 a las 15.43.33.png

Option 3:

WIFI

If you want to connect the street panel via WIFI:

1º Keep your finger pressed for 3 seconds on the upper left corner of the "configuring" screen.

2nd Select the WIFI network you want to connect to and enter its password.

3º Restart the device.

Ancla 3 Internet
bottom of page